These forums are now closed Forum Index These forums are now closed
Please see the new forums
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Krusader v 1.3 section 8.3 Moving Memory

 
Post new topic   Reply to topic    These forums are now closed Forum Index -> Software
View previous topic :: View next topic  
Author Message
sbenoit



Joined: 19 Oct 2008
Posts: 5

PostPosted: Oct Sun 19, 2008 10:40 pm    Post subject: Krusader v 1.3 section 8.3 Moving Memory Reply with quote

System:
Replica 1 TE
Multi I/O board
KRUSADER 1.3 BY KEN WESSEN

enter and test code per section 2 Sample Section
(note: manual from CD that came with system, krusader12.pdf)
<-- snip -->
? L
000 LDA #'A'
001 LOOP JSR $FFEF
002 CLC
003 ADC #$1
004 CMP #'Z'+1
005 BNE LOOP
006 RTS
? A
0300-030C
? R $300
ABCDEFGHIJKLMNOPQRSTUVWXYZ

<--- end snip -->

Now I want to copy it to my multi I/O EEPROM located at $A000
so per section 8.3 then run the small program from $A000
<--- snip --->
? $\
50: 00 03 00 A0 00 0C
<---- end snip-->

OUTPUT
<---snip --->
50: 00 03 00 A0 00 0C

0050: F8
F20ER

F20E: C8\
A000
<----end snip --->

Am I entering the data properly?
srcH srcL destL destH sizeL sizeH
50: 00 03 00 A0 00 0C

F20ER <---vector to program to copy on a Replica 1 TE?

What output should i see?

here is my output:
<--- snip --->
A000.A00C
(not matching D $0300 info)
A000: 4C B0 E2 AD 11 D0 10 FB
A008: AD 10 D0 60 8A
F20E

F20E: C8
<-- end snip -->

Note:
I did use the basic program from another post to copy to the multi I/O and did run BASIC from the multi I/O, the multi I/O works.
Back to top
View user's profile Send private message
Kallikak



Joined: 29 Jan 2006
Posts: 162
Location: Sydney

PostPosted: Oct Thu 23, 2008 5:31 am    Post subject: Reply with quote

Sorry for the slow reply - I haven't had a chance to check the forums for a few days. The problem is the MOVE routine moved from version 1.2 to version 1.3. The address you want is now F204. This information can be found in the krusader 1.3 manual on my website.

Ken
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    These forums are now closed Forum Index -> Software All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group