Briel Computers support forum

After posting this last set of measurements Vince suggested that I send my Kim in for troubleshooting, which I did. The problem turned out to be a faulty 6532. Vince replaced the chip, tested the Kim, and shipped it back to me via Priority Mail. I just finished keying in the clock program and it run...

Here's the results of my measurements:

SYNC pin 7 - 1.25V after pressing reset.

READY pin 2 - 5.0V.

Phase1 out pin 3 - 2.29V.

Phase2 output pin 39 - 2.29V.

Phase0 input pin 37 - 2.5V

Rick

Hi Vince, I just finished my Micro-Kim over a period of four very enjoyable days. Thanks for bringing the Kim back to life with your replica - it's a real blast from the past! Thanks, too, for the super fast shipment of the three missing caps. Much appreciated. I'm at a dead end right now. I just po...