Briel Computers support forum

me to

I had not turn on my one on in 9 mouths and my ram-disk mod had not lost a bit
viewtopic.php?f=23&t=861
and my battery still 3.6v

i put the nuts on my one (i hate dry joints) it was a hard geting all the swichs to line up

i think its avr 5v and pic 3.3v?
but should be fine!!
i would like to know how you got on ..
i saw one on these on eBay 4 not to much

if it was me i would use the 3.3v supply (and maybe put some 100ohm resistors on the tx,rx pin to be safe)

I tried emulating the a1200 on a atom 1.8g 4thread but it was slow.
how well dose the PI do

this is very good news hopefully a dream come true

http://www.rtmx.com/UniFLEX/

one cool link

making the current on the 88-DSK-RAM lower. I found the current on the backup battery was 2.5mA .. so i look at what can do.. i removed the AVR and the current went down to 7uA cool. here's what I came up with.. with 2 opto-coupler pc123 this mod is done close to the avr8515 so the pull up resistors...

is it possible to get an updated switch list as well??
thanks

after much looking i found this site
http://www.idb.me.uk/sunhillow/8080.html

i'm going to give it a try sometime..

i'm not sure what it was but i bump the backup switch and had to copy the .dsk again and now working!!

i'll keep an eye on it
thanks matt

I copyed zork1-3.dsk to b:
When I do b: then dir
I. Get zork1.com zork1.dat etc,etc
When I type zork1.com I get
Zork1.com?
Howdo I load zork?
(This my first time use cp/m)

nope
you must have
http://benybee.wordpress.com/2008/01/13 ... converter/

or a usb2ttl converter is the easy way

WHAT copyright on 30+ software
IMHO software should have a 10.year copyright after that ..do as you will..

also check the diode's are not backwards