Pocket Term wall wart

Talk about the PockeTerm, updates, and uses

Pocket Term wall wart

Postby jscheef » May Fri 25, 2012 1:25 pm

Vince or all,

I'm trying to find a suitable wall wart (power supply) for the pocket term. Can I use 12v or is that too much? 12v supplies are common (I have lots) while 7-9v is not (I have none). What is the maximum amperage? Does someone have a source for something known to work?

Vince, what is the size of the jack used in the PT? Is it 5.5m outer, 2.5m inner? or 2.1m inner? This little piece of information is not in the manual.

I thought I saw a source somewhere here in the forums, but I can't find it now.

Thanks,
Jim
jscheef
 
Posts: 4
Joined: May Fri 25, 2012 12:56 pm

Re: Pocket Term wall wart

Postby vbriel » May Fri 25, 2012 3:12 pm

The amperage is not the concern, but at least 300mA is good, the higher the amperage, the more the wall wart can produce if needed. So, there is no maximum, just a minimum. The voltage needs to be 7.5-9 because of the onboard voltage regulator. It CAN go above that but will get really hot. I know I've seen them at Radio Shack and Walmart in the USA. Outside the US, I can't help you much but maybe try and find a multi voltage one with a slide switch, those are pretty common.
User avatar
vbriel
Site Admin
 
Posts: 1184
Joined: Jul Tue 19, 2005 1:10 pm
Location: Ohio


Return to PockeTerm General Discussion

Who is online

Users browsing this forum: No registered users and 2 guests

cron