mechanical stability of front panel

Discuss the new Altair 8800 Micro

mechanical stability of front panel

Postby no0207 » Nov Tue 06, 2012 3:10 pm

The switches in the micro kit are delivered with a pair of nuts on them. However on all the photos of built micros I have seen so far these nuts are never mounted. I still wonder if the front panel has enough mechanical stability without making use of them - toggling the switches must impose some forces on the soldering points and on the glued distance holders. I still keep the nuts in a plastic bag, not really sure if it would be better to install them. Any opinions on that - or maybe experiences from users who have used the switches a lot?

(maybe I sense a problem where there is no real problem...)
no0207
 
Posts: 67
Joined: Nov Sun 04, 2012 12:36 pm

Re: mechanical stability of front panel

Postby elchucko » Nov Tue 06, 2012 6:37 pm

As I remember it my kit did not include the toggle switch nuts. I have a very early kit so that may be the reason. I too questioned the stability of the mounted switches as one can notice when a switch is toggled it moves. So far no problems have been reported by anyone so it may not be an issue?
User avatar
elchucko
 
Posts: 156
Joined: Apr Wed 14, 2010 6:06 pm
Location: Lincoln Nebraska

Re: mechanical stability of front panel

Postby galaga » Aug Sun 25, 2013 2:48 am

i put the nuts on my one (i hate dry joints) it was a hard geting all the swichs to line up :)
User avatar
galaga
 
Posts: 62
Joined: Feb Fri 18, 2011 8:29 pm


Return to Altair 8800 Micro

Who is online

Users browsing this forum: No registered users and 2 guests

cron