'^' instead of '\' after reset

Get help here getting your replica 1 going

'^' instead of '\' after reset

Postby jgorelik » Sep Sun 30, 2012 4:23 pm

I just got my Replica 1 kit assembled. After powering on and reseting the board, I don't see '\'. I see '^' followed by a cursor. It seems like two data bits are stuck together since, ASCII code for '\' is 0x5C and 0x5E for '^'. Could it be a bad EEPROM?
jgorelik
 
Posts: 2
Joined: Sep Sun 30, 2012 4:15 pm

Re: '^' instead of '\' after reset

Postby vbriel » Sep Sun 30, 2012 8:11 pm

Could be, but more likely solder connection. Check your 6502, 6821, and Propeller chip for any soldering issues.
User avatar
vbriel
Site Admin
 
Posts: 1184
Joined: Jul Tue 19, 2005 12:10 pm
Location: Ohio

Re: '^' instead of '\' after reset

Postby jgorelik » Oct Fri 05, 2012 5:04 pm

Got it working. 6821 chip was bad.
jgorelik
 
Posts: 2
Joined: Sep Sun 30, 2012 4:15 pm


Return to Troubleshooting

Who is online

Users browsing this forum: No registered users and 2 guests

cron